Flashforge Dreamer - Wanscam IP Camera Bracket and Spacer

Flashforge Dreamer - Wanscam IP Camera Bracket and Spacer

thingiverse

Updated 17th April 2016 This is a bracket to hang a Wanscam HW0024 IP Camera (or similar) from the front of your Flashforge Dreamer (and presumably, the Dremel Idea Builder). It may work with similar IP cameras that I haven't been able to test. Dreamer lid can still be mostly closed when this is fitted and the slight gap doesn't seem to have any noticeable effect on ABS printing performance. To open the Dreamer's front door while this is fitted, either slide the bracket to the side or simply loosen the camera's mounting screw and slide the camera out. When printing the bracket, supports will be required for the overhanging clips. Bracket should be printed in a heat resistant material such as ABS. To check if your IP Camera will fit: Gap from center mounting screw hole to furthest edge: approximately 61mm Gap from center of mounting screw hole to closest edge (as the Wanscam HW0024 is rounded at the front, this wasn't an issue): approximately 58.5mm Print Settings Printer: Flashforge Dreamer Rafts: No Supports: Yes Resolution: 0.2mm Infill: 15% Notes: Printed with Bilby3D ABS.

Download Model from thingiverse

With this file you will be able to print Flashforge Dreamer - Wanscam IP Camera Bracket and Spacer with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Flashforge Dreamer - Wanscam IP Camera Bracket and Spacer.