Flashforge dreamer/Dremel overhead filament mount guide V2

thingiverse

Having tackled some problems with the initial model, primarily the collapse of one of its arms, I decided to create a revised version two. To prevent similar failures in the future, I strengthened the arm and replaced the original glue-in stud with a robust thread screw, further enhancing its durability. Additionally, I redesigned the wheel mount to give it a sleeker appearance while minimizing unnecessary clearances and accommodating the new screw. If a suitable replacement screw cannot be found, version one will remain intact as it does not require this modification. The lid gap is still achieved using these 7mm spacers: http://www.thingiverse.com/thing:667599