Flashforge dreamer/Dremel overhead filament mount guide

thingiverse

I've been running my dreamer with filaments mounted overhead for a while, and I started noticing marks on the lid where the filament was dragging against it. The filament also wasn't flowing as smoothly as I wanted, so I decided to take action. I created a block and tally to run the filament through, mounting them in preexisting holes within the dreamer frame. This allows the filament to clear the lid and come in at an angle that's closer to its original path out of the box. I used 7mm spacers to create the gap between the lid and frame - you can find these online at Thingiverse (http://www.thingiverse.com/thing:667599). Version two of this model is now available as well - check it out on Thingiverse (http://www.thingiverse.com/thing:2014120).