Flashforge Creator Pro top camera mount

thingiverse

This is a trio of parts holding a D-Link DCS series camera at the top of my FlashForge Creator Pro's acrylic cover, with three screws coming together to expedite printing and reduce plastic usage. Its design specifically incorporates M4x12 socket head screws and M4x0.7 hex nuts. Complementing the horizontal view that this piece mounts a camera for, I designed this complementary piece to accommodate another camera for a vertical view at http://www.thingiverse.com/thing:725457. Printer Settings: Printer Model: FlashForge Creator Pro Supported by Printer: Yes Resolution Level: 0.3 Infill Rate: 40% Notes on Printing: To get these prints done, I set all three pieces to print in 0.3mm layers with a 40% infill ratio - except for the threaded rod supporting the camera. For that specific section, I used a tighter resolution of 0.2mm layers and a 100% infill ratio. The central part was built-in with supports for where screw heads end up. On the other hand, the outer parts necessitate the addition of support via the slicer to ensure accurate printout.