Flashforge Creator Pro - Sool holder - For Colorfabb 1[kg]

thingiverse

Spool holder for FlashForge Creator Pro 3D printer. The spool holder is designed to be used with Colorfabb spools that weigh 1.0 kilograms and have an inner diameter of 53 millimeters. The spool holder consists of two parts that are connected together through a tight fit or by using glue, although the use of glue is not mandatory. To provide additional structural reinforcement, I used a Hex Bolt with a diameter of 10 millimeters and a length of 65 millimeters. However, this is not necessary, and the spool holder can be printed without it. Print Settings Printer: FlashForge Creator Pro Rafts: No rafts are required for this print. Supports: No supports are needed for this model. Resolution: The resolution used for this print was 0.25 millimeters. Notes: Infill settings were adjusted to provide a strong and durable structure. The spool holder has an infill percentage of 12%. The hanger on the spool holder is fully solid, with an infill percentage of 100%. Print Time: Spool Holder: The print time for the spool holder was approximately three hours. Hanger: The print time for the hanger component was around 45 minutes.