Flashforge Creator Pro improved Dome handle

prusaprinters

<p>This is a top handle for the Improved Dome for Flashforge Creator Pro thing <a href="https://www.thingiverse.com/thing:1194887">http://www.thingiverse.com/thing:1194887</a>. It makes it easy to remove and place the dome using one hand.</p> <p>This thing was designed by customizing the parametric handle generator <a href="https://www.thingiverse.com/thing:2320611">http://www.thingiverse.com/thing:2320611</a>. If you use the stock dome or any other dome, you can customize it to your specific dimensions.</p> <p>I attached it to the dome using 3M 2Lb (1Kg) double sides mounting tape.</p> <p>A few design notes:</p> <ul> <li>The handle is attached to the dome near its front and rear walls for increase strength and stability.</li> <li>The two bases of the handle are extra wide for additional lateral stability.</li> <li>Make sure to attach the handle at the center of the dome for better stability.</li> <li>I printed it with PLA, 0.2mm 200C (higher temp = better layer adhesion), cooling fan on and material support. I also used brim to prevent the edges of the bases from lifting.</li> </ul> <h3>Instructions</h3> <p>Using the following options:</p> <p>base_diameter = 30</p> <p>handle_proportion = 2.7</p> <p>filet = 5</p> <p>base_proportion = 2.5</p> <p>hole_depth = 15</p> <p>handle_length = 125</p> <p>base_rotation = 90</p> <p>handle_bent_radius = 10</p> <p>handle_height = 30</p> <p>base_height = 3</p> <p>base_offset = 0</p> <p>$fn = 90</p> <p>bent_fn = 30</p> <p>hole_diameter = 1.5</p> <p>handle_thickness = 7</p> Category: Household