FlashForge Creator pro glass bed clamp

thingiverse

Here are some bed clamps for the glass on the old flashforge creator pro. These are much better than the binder clips because they allow you to print over the entire bed without worrying about crashing into anything! They fit right over the existing nuts holding the heated plate. All you need to do is add an extra m3 nut and washer (which is very important) on the underside. Print Settings Printer: Flashforge creator pro (old) Rafts: You can print with or without rafts Supports: No supports are needed Resolution: 0.2mm is a good resolution for this printer Infill: 20% infill is sufficient for most prints Notes: Print in ABS with no supports. Print four times to get the best results.