Flashforge Creator Pro Glass Adjustable Bed Bracket (MOD)

thingiverse

A Reimagined Version of Chewbone's Flashforge Creator Pro Adjustable Glass Bed Bracket Enhancements to Corner Piece: The screw slot is now extended along the entire length of the corner, allowing for effortless removal and swapping of these components without completely removing the pin. A taller design has been implemented, providing 9.5mm clearance for the bed, as well as a blue sheet if you still use it on top. A lip protrudes 3.2mm over the bed to accommodate glass plates up to 6mm smaller than the bed's dimensions. Additions: A blank corner piece has been added with no lip, designed to be screwed directly into place - ideal for back corners where adjustments may not be necessary. Print Settings Rafts: No specific requirement Supports: Yes, they are a must Resolution: A minimum of 0.2mm is recommended Infill: Infill density should be set at 30% or higher Notes: These parts should be printed in ABS as they will be exposed to high temperatures when in contact with the bed. It was possible to print these components directly on the bed without a raft, and a print speed of 50mm/s maximum was used to ensure accurate corners.