Flashforge Creator Pro BLTouch Mount

thingiverse

Threw this together in real quick to mount the BLTouch probe in place of the right extruder on my Creator Pro. You might be able to mirror it for the left but I haven't measured to know for certain. It goes into the hole on the block and you use the existing set screw to keep it in place. This <u>does require</u> some minor modification to the carriage itself. I just used a simple hand file to take 1-2mm off the inside front and it fit perfectly. You only need to make room for the wire connector. It's worth noting that you'll need some kind of mainboard upgrade as the one that comes with the Creator Pro/Replicator/QIDI/etc cannot really handle this well on its own. I personally converted mine to a Duet 2 Wifi. X/Y offset for me was 37 and -12 respectively but you'd need to double verify on yours. Lastly, I sized this to fit fairly low so you will probably need to use 1 or 2 thin washers above the part (below the probe) to raise it up just a bit but again it depends on your individual nozzle height. Follow the instructions in the BLTouch manual for spacing requirements.