Flashforge Creator Pro (2016) filament tube spacer

thingiverse

The filament guides on the Flashforge Creator Pro run parallel and very close to the back wall. Consequently, the filament frequently jumps past the spool border and becomes entangled, particularly with narrower and/or full spools. This spacer(s) shifts the filament guide end approximately above the middle of the spool, thereby eliminating the problem. Simply snap them into place where the guide normally goes. I discovered (regrettably, I had already designed & printed these) that numerous alternative designs are available but all are bulkier and some require more complex printing, necessitating supports, etc. I did use a raft because the base is very thin, but trimming the end would likely allow printing without it. Printer settings: Printer: Flashforge Creator Pro Rafts: Yes Supports: No