FlashForge Creator Pro 2016 Dual Nozzle Alignment Tool

prusaprinters

<p>Thanks for the original design! Had to tweak it a little for my purpose.</p><p>Made this remix to level the dual extruder on my 2016 FFCP.</p><p>Steps to use:<br>1: Remove all filament and allow nozzles to cool<br>2: Remove parts cooling fan and duct<br>3: Remove hotend cooling fans<br>4: Remove the extruder motors<br>5: Remove bowden tube mount from top of the extruders<br>6: Remove two bolts holding hotend bar on<br>7: Use the bowden tube mount bolts to attach the printed tool onto the bottom of the nozzles<br>8: Use a feeler gauge (or fold paper until the appropriate size) to measure distance of one nozzle (most owners report that one hotend is jammed and cannot be adjusted)<br>9: use the rear 2mm screw to loosen one hotend and adjust to same depth as the other one.<br>10: Tighten the screw and recheck. If both nozzles are the same, you did it! Celebrate with good food.<br>11: Replace all parts in reverse order<br>12: Re-level the bed to both nozzles</p><p>Tip: I like to fine tune bed leveling by using 2-3 skirts on my print and adjust them bed height real-time. Trust me, this method is the best!</p>