Flashforge Creator Dual - Single Fan Guard with Dust Remover Filament Tube Guide

thingiverse

This design is a combination of two models: one from Thingiverse (http://www.thingiverse.com/thing:153807) and another (http://www.thumbiverse.com/thing:26040). The left extruder was removed from the carriage as dual-strusion prints were not planned. A spacer was printed to use the stock head bracket, but it rattled; thus, an alternative was developed. A 3/4" braided cable sleeve or zip ties can be used for wire management. Printing settings include .2mm layers with 15% infill and supports (without a raft), although a raft can be used if preferred. Aquanet Unscented Super Hold spray helps avoid the need for a raft. Supports must be removed from under/inside the filament tube guide, under clamps, and in the wiring gap. The stock head is removed, along with right filament and tube guide (and any spacers). The print is then clamped around the fan, with foam, filament, and top piece completing assembly.