FlashForge Build Plate Harness Plug

thingiverse

I designed this as I despise having trash plummet down into the printer. My goal was to prevent all the trash from dropping and perhaps getting sucked inside the PSU's fans or even the fan blowing on the bootblock drivers. One similar solution exists for the Creator, but mine was entirely measured and drawn by me. It's straightforward – nothing complex – since I just detest messy plastic strands falling into the printer. You may need to fine-tune with a file if your printer isn't perfectly calibrated like this one; it's an extremely snug fit. **Print Settings:** - **Rafts:** None - **Supports:** Not used - **Resolution:** Your preference, essentially whatever you enjoy - **Infill:** I left the infill setting at 10% **Post-Printing**