Flashforge Adventurer 5m Spool Holder

thingiverse

This is a spool holder for the Flashforge Adenturer 5M because the spool holder it comes with it awful and doesn't even keep the spool from sliding off.UPDATE: I redesigned the spool holder to be longer and a bit sturdier. Because of the way the Adventurer 5M feeds filament up from below, I found that my original design was too high up on the printer, especially when the spool starts getting low.It is designed to be screwed onto the top of the machine using two screws that are already in place on the frame. On the top of the printer just above where the original spool holder is supposed to mount, there are two screws that are 29.5mm apart (on center) and about 22mm from the edge. Unscrew those screws, screw them into the printed object's holes until they just start to come out the other side, place it back on the printer, and then tighten.