Flashforge Adventurer 4 calibration test

thingiverse

This print is a single layer test print designed to surface levelling issues on your Flashforge Adventurer 4. The design is 220mm x 200mm to fit the entire printable area of the ADV4.The ADV4 has a 9-point bed levelling system that does not provide levelling values for the spaces in between. The 9 points are not sufficient to get a true picture of where your printer is too close or too far away from the nozzle. The diamond shapes represent a travel of 50% from each measuring point along with a number of mid-points in the center of the bed. Use the print to visual problem areas. Avoid scaling the STIL file because it will alter the 02.mm layer height.