Flashforge Adventurer 3 Filament guide bowden tube feed and door holder

thingiverse

I`ve created this because I don`t want to open the side panel every time when I change the filament. Used the same bowden tube as it is inside the machine from the extruder to the nozzle (OD=4mm; ID=2mm). Three different connectors depending how you want to make it. I`ve had extra connector laying around M6x1, I`ve printed the file without thread, so I cut it myself, screwed the M6 connector to it. To fit the printed part into the printer extruder you`ll have to unscrew two screws to move the extruder a bit so you can see all three screws on the side of the extruder, unscrew two bottom screws and the top one just a little bit. Take out the original filament guide and put the new one in.