Fixed Angle FPV Camera Mount Generator

thingiverse

OpenSCAD FPV camera mount generator. TL;DR ==================== + Edit the first 6 settings + Don't bother changing $fs + Render to see curves and save STL + Dimensions are in mm + Visit http://www.openscad.org/ for software to render this Using the Generator ==================== Simply change variables to suit your frame, camera, and preferred amount of camera up-tilt. Sensible defaults are set for most variables so you only need to change a handful of them for most applications (example below). If using OpenSCAD, do a proper render to see curved corners due to the way fillets are built. You also need to render it before exporting a STL file for printing. If you don't have OpenSCAD installed, use the 'Open in Customizer' button to generate your STL file. This seems a bit buggy though so your mileage may vary. Common Settings ==================== The common settings you need to change are as follows: Example is for a FPV Flightclub Proton - Runcam Sparrow Micro - 2.1mm lens // centre to centre **standoffSeparation** = 31; // width of the camera body at the mounting screw point **cameraWidth** = 19; // outer diameter of the lens **lensInnerDia** = 12; // from the centre screw to the back of the lens ring **lensOffset** = 7; // how far the camera sits inside the frame, use negative values to sit forwards **cameraInset** = 0; // amount of material around the lens **lensRingThickness** = 2.4; Feedback & Suggestions ==================== I've only used this to make mounts for two different quads and cameras so far, so if you have any suggestions for improvements please let me know in the comments.