(FIX) Satsana Fan Duct Remix for Micro Swiss Direct Drive Extruder - Creality CR-10 & Ender 3 Printers + CR Touch

thingiverse

This is a remix of Skia_MKX's remix of Satsanas design for the fan ducting for the micro swiss direct drive conversion for the ender 3's and the CR-10s to allow use of the CR-Touch. https://www.thingiverse.com/thing:4933205 The reason I remixed this was because there was a tab that was left on that could cause the CR-Touch support to break when trying to remove. This design will allow you to use supports from your slicer that will be easier to remove. If you use Cura, I recommend tree supports. I also included a bracket that could be glued to the CR-Touch support since the orientation of the print causes the bracket to be weak and break with the grain. You also want this to be very rigid since it is levelling the bed. The new bracket fits on top and behind the CR-Touch support and must be printed flat with the holes flat on the bed. This will allow the strength of the layers in this orientation to provide very strong support and rigidity to the CR-Touch. I would print this in PLA since it is more rigid. Just super glue it.