Five33 Switchback alternative TPU parts

thingiverse

I am not a fan of the unicorn turtle fin type thing, and the camera sticking out all alone; so I turned the top plate around (switched its "back"... haha). The SMA mount and arch weigh around 3g, the camera mount weighs about 1g so it's actually lighter than the stock setup. Screws are not necessary on the SMA mount but the holes are there to use if desired. It can be used with the top plate either direction. Print with the arch laid flat. 50 degree Runcam Nano Camera Mounts: The camera mounts are only if you have enough room without running into the stack, I recommend at least a 3mm gap because when the standoffs get bent you can damage the stack and camera if it's too tight. The top plate must be reversed and the numbers are the distance the mount hole is behind the center of the standoff. The top plate must be filed just a tiny bit to fit the lens on the "-4.5mm" one. The "-2mm" screw-less one does not require any mods but takes some careful force to install the camera to the mount (lens snaps into it, do not twist, helps to pull "tubes" apart). Do not worry too much if the little nubs for the screw holes don't print great, the camera is held by the lens but the nubs do help a little. My Nanos are 1.8mm lens I do not know for sure if the 2.1mm are the same diameter. Edit 5/18/20 Added zero offset (screw hole of camera centered on standoff) in 45 and 50 degree. Works with Runcam Racer Nano and Racer Nano 2. For Nano 2 run upside down and set "flip-HV" to get the plug out of the way of the stack. Also added 45 deg Foxeer Nano Razer Mount