Fitness Ball Stand

thingiverse

This model creates a stand that holds a fitness ball in place so it doesn't roll away. The stand is sized to hold a large 29-inch ball, but can be adjusted for smaller balls as well. After it's printed, the wide end of the "legs" fit into the vertical slots of the four trapezoids. The thin parts of the legs slide into the center base section and can be adjusted in and out to fit the ball perfectly. It's essential to dry fit everything first, then glue in place with CA glue. Note that the legs are not flat across the bottom, so they can be adjusted for different balls. Make sure everything is flat and in contact with the ground before gluing it up. This stand was designed using Tinkercad and can be edited online at https://www.tinkercad.com/things/6Oywytv745V.