Fitbit Ionic Watch Stand - Thing

thingiverse

I had to remix this stand for my Fitbit Ionic, so I could make it work with my device. Getting it right was a challenge that required going through a lot of plastic iterations. Initially, I aimed too high by trying to incorporate fancy cable routing, but the USB cable proved impossible to route as desired. In the end, I settled on matching the original design and this one works really well. I used "Skin" filament to print another version of this thing, which turned out great. The improved angle and opening make it easier for better centering of the watch and facilitate cable insertion. It's a bit tight when inserting the USB, but with some pressure, it will go in. You may need to use a pick or screwdriver to get the USB cable tip to turn, but once you do, you should be good to go.