Fishtank T5 Led night / mood light adapter

thingiverse

Fishtank Mood Lighting System: Enhancing Late-Night Scenery with Advanced LED Strip Installation This custom-designed fishtank lighting system leverages an available T5 TL fixture by adapting a standard ledstrip to produce an immersive and realistic moonlit ambiance, ideal for observing nocturnal fish in their natural behavior. Inspired by the unique visual experience offered by moonlight, which casts a soothing blueish hue on aquatic environments, this setup incorporates an RGB controller. However, initial findings indicate that accurate color calibration can be challenging due to variability in led current delivery over time. Fortunately, by adjusting settings and embracing a more nuanced approach to color representation, users can enjoy breathtaking visual results, allowing the nocturnal fish species within their care to thrive and showcase their nocturnal activities with increased clarity. Optimized Printing Parameters: * Rafts: Negligible Impact on Final Print Quality * Resolution: Achieved at 0.3 mm Precision Levels * Infill Density: Adjusted between 20-30% for Maximum Strength Assembly Instructions for Fishtank Mood Lighting System: To set up the fishtank mood lighting system, you'll need the following components: 1. **LED Strip:** 95 cm of sealed (RGB) LED strip accompanied by a reliable power supply. 2. **Cable Connection Components:** Either four wires specifically tailored for RGB applications or an eight-wire flat cable that can be configured to facilitate this setup, similar to how it was initially implemented with the used configuration. **Required Print Pieces:** * One Aluminium profile, precisely measured at 95 cm in length and with a 15x15mm cross-sectional dimension. * Two printed adapters that are crucial for seamlessly integrating the LED strip within the fixture's existing framework. * Silicon paste/glue for additional stability and waterproofing. Assembly Protocol: 1. To ensure optimal functionality without short circuits, both ends of the ALu profile must be carefully identified with approximately 3 mm in depth to separate it from direct contact with the metal surface. 2. Next, each side's wire connections are soldered securely onto their designated segment on the RGB LED strip. 3. By positioning and affixing the led strip into place within its specially tailored slot in the ALu profile. 4. Conduct a thorough functional check to guarantee seamless operation without power outages or anomalies before proceeding. 5. With both components correctly secured, silicone paste/glue must be applied evenly to seal each interface completely between parts for water resistance. The final assembly steps involve carefully inserting the integrated lighting system into any suitable holding fixtures that resemble conventional TL light mounting systems in structure and dimensions.