fishing Rod building- dryer chuck +ROLLERS

thingiverse

My old project looked pretty bad, I have to admit it was quite ugly.... I found this: https://www.rodbuilding.org/photopost/showphoto.php/photo/14549/title/triangle-chuck-rod-dryer-chuck-2c-the-solution-sketch/cat/508 https://vimeo.com/119632829 Designed with the ability to be removed from the board for storage. Or use a longer board if necessary. Triangle Chuck. Rod dryer chuck files: th11, th22, th33 The motor hole is 5mm. Drill and super glue it, or tap it to size. Used six 2.6mm x 16mm self-tapping screws. Two M2 x 10mm nuts and bolts were used (must be drilled for installation). Three Elastic Bands are used. Support rollers, files: s1, s2, s3, s4, 3* w Two M5 hex 15mm bolts and nuts were used. Three M3 bolts and nuts were used for the rollers. Rollers built for 3mm x 11mm x 4mm bearings. Under the hand, three Elastic Hair Bands are used for the rollers. Motor mount: L, motor connected with 2.6mm x 16mm self-tapping screws.