fishing lure version 3

cults3d

This fishing lure combines features of the following two models: https://cults3d.com/en/3d-model/various/leurre-pour-la-peche-version-2-parois-brillantes https://cults3d.com/en/3d-model/various/leurre-pour-la-peche It takes the general shape of version 1 seen from above, slightly modified, and adds bright flanks similar to those of version 2, although less high. Clipping the two other models was not a problem with "simple" or "+" plates, but with "effect" plates (like the metal "silk"), probably with more "loads" in them, and less tenacious; I observed some breaks during assembly. So I replaced the clips by simple studs to be glued. They hold very well, when the two hulls are assembled with neoprene glue (or hot glue, but you must be quick to assemble the two parts before the glue gets too thick and cools). They can thus stick everything to the neoprene; the olive lead lengthened by 15 or 20g, the two shells, and the shiny ribbon. Note that by leaving the ends of the lead where the swivels are located free of glue, you get a modest "noise" inside. You need: -your two hulls printed with the "fishing lure version 3", without forgetting the "caudal" piece, unless you put a triple hook . -broken stainless steel rings in the right sizes (such as one of 6 mm diameter to leave a freer movement to the hook, and 10 mm diameter for the 2 others connected to the ends loops, for example) -broken ring pliers are recommended. -neoprene glue -scissors for the ribbon -long "extended olive" lead weights of 15 or 20g; depending on the model, you may have to cut one of the swivels with pliers if it doesn't fit from the beginning. -hooks with eyelets, the size you like, but for this lure, between 1 and 2/0 look good. -You can cut in the width of the ribbon of 10mm if you can't find 5mm. I recommend the ones that are shiny, shimmering or iridescent.