Fish Skeleton Lure Swimbait

prusaprinters

This a remix of Fish Skeleton Magnet by DDRBoxman (Thing:21951) I thought it would be funny to make it into a fishing lure! Used TinkerCAD to chop of the original STL into sections and added eyelets. Probably the third thing I "made" after getting a 3D printer; so it's rather crude in design, so your slicer program may say it has errors in the drawing, but it still prints fine. Assembled by tying the sections together with 30lb line; you can add extra sections if you want a longer. Also you can scale it up or down on your slicer program. PLA tends to float, so either print with 20% infill and drill some small holes to let water in. Or print 100% infill. Also adding a small sinker to the line before the lure helps keep below the water. Also it works; because it makes so many vibrations underwater. Use triple hooks for best chances of hooking fish Print Settings Printer Brand: Anet Printer: A8 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 20 Filament: Any PLA Any Notes: Print 0.2mm layer height 1.2mm wall thickness for top, bottom and sides as a minimum recommended 20% infill Or print 100% infill to help it sink better. Use supports for the eyelets Category: Sport & Outdoors