Fischertechnik cooler with LED

thingiverse

To print this, you must first increase your FT Printer's maximum height. The FT Printer's height can be increased by removing the plug from the Z-axis and reattaching it to the top. Next, navigate to the EEPROM settings in the printer firmware and adjust the Z-axis height (I set mine to 80mm; estimated at 83mm). Be aware that if you don't change the EEPROM setting, the fan will have incorrect dimensions. Here are some links for upgrading your FT-Platine: http://www.kinder-technik.de/fischertechnik-3d-drucker-filamentkuehlung-nachruesten/ https://www.youtube.com/watch?v=K5guIo8dIh8 After successful printing, especially the inner corners and edges with a file. The hole should be drilled with a 3.5mm drill bit and then a 4mm drill bit. Printer Settings: Printer: Fischertechnik Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 1:1, 0.2mm Infill: 20-30% Notes: Use colorless filament Wall and bottom thickness: 1mm Use Firmware EEPROM to: X-axis steps per mm: 675,000 Y-axis steps per mm: 675,000 Z-axis steps per mm: 1,356,000 Extruder 1 steps per mm: 115,000 Max z-length: 80 mm You will need a minimum of 77mm for the Z-Axis.