Firmware Tft i3RS32 MakerFr

thingiverse

Here is the rewritten text: An improvement for our TFT 32 screen from i3RS MakerFr by Romain available on https://www.makerfr.com/ I added some ideas I picked up at robscar with a dash of MakerFr flair. In the Tools menu >> More >> Add buttons to do - Offset - Z+0.025 - M502 - M500 - P.I.D Autotune - Z-0.025 - Preheat - Save This gives us the ability to perform a Z-Offset and correct the distance between the nozzle and the bed via the Babysitting commands coupled with M851. The bed once leveled is saved in EEPROM, very practical every time you change nozzles. I also added two buttons for EEPROM, M502 & M500, which were missing on MKS TFT, it's now possible to enjoy them. I put a button for preheating the machine, by default, the nozzle preheats at 200 degrees and the bed at 50 degrees. It is possible to modify these values in the config file. In the "MORE" menu which can be accessed during printing, I added 5 buttons that are more or less useful depending on users. There is therefore the possibility of adjusting Z offset during printing, it's very practical. A button for M500 to save after restarting. Two buttons start and stop for LEDs, useful at night not to light up the neighborhood where attract pests ^ ^ I reused Romain's design for the buttons so I wouldn't be out of place :) Be indulgent, I'm just a beginner. I think I've covered all the improvements and hope to satisfy more than one. Regarding installation, you only need to transfer the files to an SD card and insert it into the SD port on the screen. You will also need to activate if not already done, the Babystepping function in your firmware's Configuration_adv.h file. Here is an excerpt from mine: @line 992 for my part. Edit 16/04/2020: Error in code with light buttons, corrected. Enjoy