Firmware 2.0.5.3 Bugfix - Sidewinder X1 - SWX1 - SKR 1.4 Turbo - BTT TFT35 V3 - BMG Clone - Sonsorless Homing XY

thingiverse

It's the firmware for a Sidewinder X1 with Fysetc Extruder (BMG Clone) and Volcano/V6 Hotend (Clone). If the original extruder is still being used, it may be necessary to adjust the direction of the extruder motor again. Also, the E-steps of the extruders need to be adjusted. Marlin: 2.0.5.3 Bigfix Version Display: BTT TFT35 V3 LCD Language: German Board: SKR 1.4 Turbo Stepper: TMC2209 v1.2 Mode: UART RMS XYZ: 600mA RMS E: 500mA Steps: 256 Classic Jerk enabled: no BMG Extruder: yes Volcano/V6 Hotend: yes Sensorless Homing: XY Original Z-Endstop: yes Eeprom enabled: yes Printcounter enabled (M78): yes SDCard Support: yes Individual Axes Homing: yes Linear Advance enabled (K0): yes Cancel Object enabled (M486): yes (untested) After flashing, don't forget to execute M502 and then M500. Now you can make your settings again. It is recommended to do PID-Tuning, Extruder calibration etc. You can adjust about 95% of the settings through the LCD display, and an adaptation of the firmware is not necessary. However, I'm providing the sources so that individual adjustments can be made. And here's the used hardware: SKR 1.4 Turbo: https://www.amazon.de/dp/B082SWXS93/ref=pe_3044161_185740101_TE_item SKR 1.4 Board Mount: https://www.thingiverse.com/thing:4345202 TFT35 v3: https://www.amazon.de/dp/B07VWF4W3J/ref=pe_3044161_185740101_TE_item TFT Mount/Case: https://www.thingiverse.com/thing:4179249 USB Extension: https://www.amazon.de/dp/B075FVGH8H/ Micro-SD Adapter: https://www.amazon.de/dp/B07GR2HT2Q/ Noctua Fan: https://www.ebay.de/itm/164272913976?ViewItem=&item=164272913976 Stepdown Module: https://www.amazon.de/dp/B07DP2MDJQ/ref=cm_sw_em_r_mt_dp_U_0.eaFbB175KB4