Firefly Light Toy / Keychain

cults3d

Easy to build toy or key-chain light shaped as stylized firefly. Model is available in two variants: one held together by two neodymium magnets, second by small screw. Keychain version has a small hole in the front. Size (approx): 8 x 5 x 1cm Unprintable parts: 1x 5mm LED (green) 1x CR 2032 battery 1x 6x6mm push-button 2x 6x3mm neodymium magnet OR 2x6-7mm screw (longer can damage the shards) piece of wire (6-10cm) Printed parts: 1x body (choose from variants) 1x light (transparent) 1x shards (choose same variant as body) Assembly notes: see pictures step-1 - step-3 (little bit outdated prototype but still valid workflow) push-button and magnets should be carefully glued in place body and light should be glued together, it's much easier after placing the LED there battery should be oriented with + side up; the wire between + and push-button is just squeezed on it's place check the LED polarity carefully! no resistor is needed - the battery is not strong enough to burn the LED