Finger Labyrinth

thingiverse

This is an ancient labyrinth design dating back some 2400 years sized for your finger. The uploaded STL is 180mm wide by 169mm deep, and about 6mm tall. Thus it easily prints without rescaling on common 200+mm printers. When slicing this, TURN OFF the "combing mode" (in Cura, this is under Travel settings). When combing is enabled, a maze or labyrinth model will cause the printer to spend most of its time navigating the walls of the labyrinth, and will cause the print to take several hours longer (3-4 hours for this particular object). Otherwise, 20% fill and 0.20mm layer height make for good prints. Once printed, explore without worry, there is no minotaur in the center.