Finger Door Pull, Small Round

prusaprinters

<p>This round finger flush knob is for cabinet and doors that can be opened/closed with your finger. &nbsp;</p><p>You can install it in panels greater than 13mm by drilling out a 1-½" diameter hole 12 mm deep. &nbsp; I was able to do that in a scrap 2 x 4. &nbsp;By drilling until the drill just starts to poke through the wood, it will locate the center. &nbsp;You can then use the drawing as a template to locate the hole center on the back of the frame and mark the 3 mm clearance holes for the 3 mm screws.&nbsp;</p><p>For any thickness wood frame you can force the 35 mm press fit cylinder onto the knob and press-fit the assembly into the 1-½" hole. &nbsp;Guaranteed with my reputation, it will not come out, if you use the 38.1 mm outside diameter ring. &nbsp;Other rings are also available that are a bit looser in the hole.</p><p>There is a small circular indentation on the front that shows where to push and where the center of gravity that closes the flap is located. &nbsp;Play with the axis to see how you want it to open and close. &nbsp;</p>