Final

thingiverse

Instructions for the Customized Version of the Phone Case To create your custom phone case, select from the following options: * Depth of Text: Set to 0.6 units deep * Height of Phone Case: Choose a height of 27 units * Base Height of Case: Select a base height of 7 units * Countersink Depth for Screws: Use a countersink depth of 10 units * Font Used for Lettering: Select the write/Letters.dxf font file * Screw Holes Left or Right Side of Phone: Choose to exclude screw holes on both sides * Back Angle of Case: Set at an angle of 1 degree * Countersink Size for Screws: Use a countersink size of 3 units * Font Size Used: Select a font size of 6 points * Modifier for Text Y Position: Adjust text y position by a factor of 1 unit * X Position for Phone Charging Port: Set at 61.2 units from the front edge * Z Height for Charger Location: Position charger at 9.2 units deep from front edge * Selected Text to be Printed: Choose "Wes" * Exclude Screw Holes Right Side: Choose to exclude screw holes on right side of phone * Thickness of Case Wall: Select a thickness of 1.5 units * Diameter of Screws Countersinks: Use countersinks with diameter 8 units * Diameter of Screw Holes: Create holes with diameter of 3 units * Diameter of Screws: Choose screws with diameter 3.85 units * Slack Allowance in Design: Include slack of 1 unit between components * Hole Depth Adjustment: Set to a hole depth modifier value of 0 units * Angle Inside Curve of Case Band: Create an inner angle at 2 degrees * Band Width Outside Curve of Phone Case: Choose band width outside curve at 2 units * Slack Value for Screw Alignment: Use slack allowance value of 0.2 units for screws