Final Fantasy VII: Remake Shinra Infantryman Standard Helmet

thingiverse

The standard issue helmet for Shinra Electric Power Co. infantrymen is a non-regulatory model intended for display purposes only. ***************IMPORTANT/WARNING/CAUTION********************************* This helmet fails to meet any established safety standards and should be used exclusively for cosplay or exhibition. ****************QUICK NOTE BEFORE PRINTING**************** Before printing, it's essential to measure your head circumference and adjust the print size accordingly. The original circumference is 2.53 inches. To calculate the print size, use the formula provided in the accompanying photos to determine a suitable scaling factor. For instance, if you have a head circumference of 19 inches, solving for the radius yields r=3 inches. To adjust the print size from a radius of 2.53 inches to 3 inches, apply this formula and solve for x: 2.53in*x = 3in x = 1.19 (The print size should be approximately 119 times the standard print size.) When preparing the helmet for wear, leave additional space to accommodate padding or a chin strap. For an authentic look, consider using a chin strap like the one available on Amazon: https://www.amazon.com/Andux-Helmet-Chin-Strap-TKXBT-01/dp/B074QGXST1/ref=sr_1_1?dchild=1&keywords=tkxbt-01&qid=1583240042&sr=8-1 To facilitate gluing, note the contact points marked by bumps where the helmet interacts with each component.