FilRight Spindle Boxes and Dropper

thingiverse

Here's a design for storage containers and boxes that can fit your FilRight 1.5kg PLA (and most likely other) filament spool. There are three versions of the box: one slot, two slot, and three slot. I'm planning on making a couple more that are half the size of the spindle rather than a quarter piece. I also included a piece to put in the center area of the spindle, allowing you to add more stuff there. Added to this, I have three "lifters" that fit in this cylinder, making it easier to take out the stuff you put in the box. PLEASE NOTE: The lifters haven't been tested yet but should be printable and work fine. EDIT I added some stacking elements that let you stack the spindles on top of each other so they stay in place. There are two versions, both with a longer version for more stability. Stacker Big -- Fits in the big holes that the spindle has and acts as the main spot to keep it stacked. Using these without the small ones allows you to swivel the spindle as long as you don't use the center piece with droppers because you won't be able to get it out completely. Stacker Small -- These fit in the several smaller holes. Unfortunately, there seems to be a lot of discrepancy in the position of these holes so matching them up might be difficult. I tried it with 4 empty spindles and not all of them matches up. They also vary in size so a little glue might be needed. I only use the Big Stackers myself.