Film holders for dslr scanning 35mm 6x6, 6x7, xpan

thingiverse

These are film holders for scanning with a dslr or mirrorless camera with a macro lens. A phone or light table and a repro stand are needed to complete your set-up. The curved film path keeps the film stable and flat at the film gate of the adapter. Printing: This was printed in PLA 0.2mm layer height at 200 degrees with a heated bed at 60 degrees. Calibrate your e-steps for this print as the film path is narrow and overextrusion will clog it up. Make sure to put the Z-seam left or right, so that the film path is printed in a single conitinuous motion without stops. This helps to ensure that the film will move through smoothly. You need to print 2 copies of a design and then bolt these together with m6 or m8 bolts. Printing times depend on your print speed bu vary from roughly 6-10h per half.