filletcube() OpenSCAD module

thingiverse

This module creates a cube in OpenSCAD with rounded edges using fillets, offering faster rendering speeds due to its avoidance of Minkowski or Hull methods. To use: Provide the dimensions of your cube as an array [x, y, z] for the first parameter. Next, you can specify additional parameters to control the side, top, and bottom fillet radii. You can use side=, top=, and bottom= followed by four values that correspond to the radii of each edge counted clockwise from front, left, right, back. For centered cubes, set the optional x, y, or z boolean parameters individually or group them under center for full centering capabilities. Don't forget "filletcuberesolution," which is crucial as it controls the number of segments on each rounded edge. Smaller resolutions increase detail at a cost of increased calculation complexity as indicated by $fn's growth in effort. Each parameter, except for your cube's dimensions (first array), remains optional to let you customize freely according to need and performance considerations