Fillenium Malcon Remix 2 pieces Large Print Prusa i3 MK2

thingiverse

This is a Remix of askenall's fillenium malcon which has been split into two parts with easy-to-use pegs for easier printing and quicker assembly. The model as scaled measures 248mm in width and approximately 355mm in length when fully assembled. No supports are required, only a good-sized brim (8mm) is needed for the bottom half. You can print both halves at once or rotate each one diagonally by itself and scale it up slightly to increase the model's width to just under 300mm for the largest possible size with two parts. I based these print sizes on the Prusa i3 MK2 bed, so feel free to adjust the scaling as needed and enjoy. Print Settings Printer: Original Prusa i3 MK2 Rafts: No Supports: No Resolution: 0.2