fillenium malcon

thingiverse

Hi everyone, I've increased the scale of my Millennium Falcon model by 140%, making it easier to print the parts. However, even with the increased size, I've had issues with poor quality prints due to their small size, which can be time-consuming and frustrating. To avoid wasting over 120 hours printing high-definition models, I'm providing you with separated parts that you'll need to reprint and add to your own Millennium Falcon. First, locate the capacitors on the rear of the ship - you'll require 52 of them. Print these in groups of no more than 10 at a time, as printing too many simultaneously can cause problems for some unknown reason. Next, remove the original gun barrels from the base and print the new ones with four barrels each. The brackets for the dish are also provided in two separate files - one for the left side and one for the right side. The dish itself is included, as some users find it easier to replace it when printing the brackets. If you're doing this, make sure to trim a thin amount of the attached dish from the brackets. I printed the entire model in ABS with a 0.1mm layer height and used a raft due to the size of these parts. Remember that I've increased the scale by 140%, so be cautious when printing these larger parts and adjust your settings accordingly.