File holder

thingiverse

Here's your custom toolbox: Instructions Use these options to make it unique: closed_bottom: Set it at 0.0 holder_y_count: Choose a value of 2 holder_angle: Hold the angle steady at 0.0 degrees holder_x_size: Adjust this to 7 units wide holder_offset: Leave it as is at 0.0 taper_ratio: This should remain unchanged at 1.0 holder_cutout_side: Opt for 0.0, please holder_x_count: Set this count at 3 strength_factor: Give the material some extra oomph with a value of 0.66 corner_radius: A 30 unit radius will be fine, thank you wall_thickness: Hold it together with a wall thickness of 1.85 units holder_height: Keep it steady with a holder height of 15 units holder_y_size: Maintain its size at 7 units