Filastruder Electronics Enclosure v3 & Hopper Funnel v3 (Based on the original by Tim Elmore)

thingiverse

The revised front panel includes "Filastruder," "MAIN," and "MOTOR" labels, as well as strategically placed vents at the top and an angled support for the panel itself. Additionally, there's a screw-down tab on the left side to securely fasten the Sestos controller without needing extra attachments. The holes accommodate #8 screws, matching Tim's design, with the exception of removing the front right upper hole due to uncertainty about its purpose. Distinctively, the hopper boasts a tapered bottom rather than being flat. Following Tim's instructions, the printing settings are: 40% infill, three shells, and full support – particularly useful for the screw mount on the left side and providing even switch openings. While ABS was used during printing, PLA might be a better choice due to its properties.