Filaments Wall Hangers

thingiverse

Filaments Wall Hangers... These wall hangers hold filaments in place, supporting up to twelve rolls, six on top and six on the bottom. Each hanger is divided into two parts, allowing for seamless printing on a machine and secure attachment via countersunk screws and nuts. To prevent tubing from falling off, the hangers feature stoppers. Remember that four distinct parts must be printed: two pieces for the right side and two pieces for the left side. For Hardware: Four 4mm countersunk screws are required. Four 4mm nuts are also needed. Four 6mm countersunk screws with anchors are necessary. Two 20mm diameter stainless steel pipes, each 60cm long, will be used.