Filament Spool Storage Shelf Bracket for Peg Board

thingiverse

This bracket works with 6-inch pegboard hangers and 1/2-inch electrical conduit. Two versions are included: I designed both to print without support, but the version with a mid-span arch had issues printing. The ends of the arch portion curled upward as printing progressed, causing the y-axis to jump out of alignment. A bracket without an arch will print fine without support, while the arched version should work with support in place. Two sets of holes near the bottom of the sides are sized for 3mm screws and secure the pegboard hanger into the bracket. The conduit retaining rings also feature holes for 3mm screws to lock the conduit securely. For my setup, I didn't need these locks; I used three supports for a 48-inch shelf width (120cm). This storage system can hold approximately 16 spools of filament or boxed filament. It's my third DIY project aimed at consolidating filament on one shelf, freeing up space on my pegboard and workbench.