Filament Spool Holder with a couple mods

thingiverse

I Made a Couple of Tweaks, but It's Not Really a Remix I'd Call Mine. 1. I Added 2mm to the Studs Where the Bearings Sit So There's More Material Holding Them When They Get Melted and Squished. 2. I Added a Flat Section, About 0.18mm High (One Layer), to the End of the Screw to Act as a Brim, So Everything Prints Out Together Easily. Don't Forget to Trim It Off After Printing, or You Won't Be Able to Assemble the Screw and Knob Properly. 3. I Flipped the Slider 180 Degrees so It Defaults to Printing on the Build Plate by Design. The Knob Remains Unchanged. Just Make Sure to Attach the Screw to the Base Before Gluing the Knob in Place.