Filament Spool Holder for Snapmaker 2.0 Modification

thingiverse

I made the original Spool Holder designed by Jaz939 and liked it a lot! But I had changed where the Snapmaker Spool mounting bar hardware was located on the enclosure. I put it on the back of the enclosure flat against the back acrylic panel. See pictures. While the original design worked fine, it was hard to unscrew the nut with the spool located on the back panel. So I added a handle that extended just past the edge of the spool itself. This created something to grab onto when trying to unscrew the nut. The handle is long enough to extend past the spool, but not so long that it will run into the screw holding the mounting bar to the back panel. This is a remix from https://www.thingiverse.com/thing:4703292