Filament Spool Holder for 3/4" PVC

thingiverse

The stand is another Thingiverse model created by Tswaehn, available here: https://www.thingiverse.com/thing:2086522. It comes equipped with a spool adapter, but requires a 6/8mm bolt approximately 8-10cm long to secure it properly, along with wing nuts to prevent the spool adapter from falling off and causing the entire spool to drop. I utilized a considerable amount of 3/4" PVC lying around. The spacers are each 10mm in length, so all that's needed is to print as many as necessary to maintain the desired position of the spool to PVC adapter. I'm thoroughly satisfied with this setup; it's a straightforward yet sophisticated solution, and I hope some of you will find it equally useful.