Filament sponge cleaner holder and clip for 1.75

thingiverse

Based on another print I saw here, but redrawn with improved settings for better ABS prints on my FFCP, along with a stronger clip. Print Settings: Printer: FFCP Rafts: No Supports: No Resolution: 0.2 Infill: 100 Notes: ABS material, 60 print speed, 100 travel. 30 minutes to print Just cut some sponge slightly larger than the holder's outer dimensions and shove it in until it's fully inside. Cut your filament at an angle if you have a sharp point from extracting it from the extruder; that will work fine. Push the filament through the sponge and out the other side, being careful how you hold it so you're always facing away from your face and hands when dealing with sharp filament. I also add a few drops of mineral oil to the sponge, which helps things run smoothly. I've made one for each of my rolls of material, and they stay neatly on the roll, sitting just below the entrance to the feeder tubes at the back of my FFCP.