Filament Space Filter

thingiverse

Print a delicate dust-gathering spaceship filter in three-dimensional form, featuring retractable attachment slots for securing lengths of filament or fiber strands. 1. Generate the design via your printer, allowing sufficient room around it as you proceed. 2. Smooth out the rolled fabric to match its intended diameter, taking care not to stretch the remaining material too tight. 3. Locate one end within an attached slot and fasten securely. 4. Release the spool, allowing the rope or fiber thread to hang free within the container. 5. Attach another segment to the holder opposite your previous move by running it through an opening in this filter module, making sure not to stretch too hard against your tension setting before clipping shut the first segment. 6. Tighten firmly with one hand on each part - ensuring equal distribution across their respective paths should cause zero obstruction when trying push these together. 7. Remove extra filament once completed by cutting along marked lines carefully not letting excess get everywhere. 8. Proceeding to full completion, make sure all sides fit together seamlessly inside given dimensions while leaving some wiggle room left over. 9. For an even more personalized feel insert any other material of choice you wish such as rope bits fishing line etc..