Filament Sensor housing that fits the E3D Titan Extruder

thingiverse

I obtained this filament sensor: https://www.banggood.com/1_75mm-Filament-Material-Detection-Sensor-Module-For-3D-Printer-p-1244283.html. Initially, there was too much friction. Consequently, I redesigned the housing to utilize two small pieces of bowden tubing. This modification also allowed the sensor to fit seamlessly on the Titan extruder. Firstly, drill all the way through with a 2mm drill bit so that the filament can pass freely. Additionally, carefully drill both ends with a 4mm drill until you reach the depth stop. Next, use two M3 Brass inserts in the bottom of the housing and ten millimeter M3 screws on the top of the housing. Interactive model viewer and Fusion360 download link: https://a360.co/2MA0uKH.