Filament Sensor Guide

thingiverse

**Update 25-08: After using this for a while, i learned using a filament sensor as shown in the photo is NOT a good idea, the curve of the filament is to sharp and might break. I checked the "work-in-progress" with this thing since I do plan to remix it to support my type of sensor in a better way.** Not that much of a remix, but the thing I based this on contained other objects I did not want in the STL. Since I couldn't "ungroup" and discard those in my slicer I used Tinkercad to remove it, which was quite some hassle. Also it was not designed for my Filament sensor per se, but I attached a photo how I still made it work. You need a M3x25 and a M3 hex nut as well (actually two if you have a fitting filament sensor).