Filament runout sensor for CR-10
thingiverse
Modified version of stevenfayers' filament runout sensor. I upgraded to Marlin on my CR-10 3D printer and was using his version till then... With the M600 command triggered by octoprint, the filament now moves freely when retracted, no longer stuck against the sensor mount. Filament sensor mount for Creality CR-10, designed specifically for the type of filament sensor shown. Requires 2x M3 x 12mm screws and nuts. PTFE version available. <h1>Raspberry Pi Connection</h1> Connect to Raspberry Pi GPIO pins as follows: https://www.element14.com/community/servlet/JiveServlet/previewBody/73950-102-11-339300/pi3_gpio.png Positive signal connected to pin 1. Sensor output connected to pin 7. Ground connected to pin 9. <h1>Octoprint Setup</h1> Install the "Filament Sensor Reloaded" plug-in and set it up according to the attached image.
With this file you will be able to print Filament runout sensor for CR-10 with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Filament runout sensor for CR-10.